|
|
|
Who's Online
There currently are 5951 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
helpful manual.good service.Quick response.will use again
 ;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
A2 / NICAM / Sound Multiplex
� The CH I / II button is only useful for NICAM and sound multiplex signals. Otherwise pressing this button will have no effect.
BILINGUAL / DUAL sound broadcast
When bilingual program is received, sound mode display appears in yellow as shown on right. Press the CH I / II button to select the sound to be heard. Each time the button is pressed, I, II or � (force mono) appear cyclically on the screen. When receiving NICAM signals, NICAM display will appear as below.
8 NICAM [II]
Sound multiplex signal received
Yellow [I]
Yellow [II]
Green
NICAM signal received
Yellow
Yellow NICAM [II]
Green
NICAM [I]
Select I, II or
(force mono) to hear the CH I, CH II or MONO broadcast respectively. 8
STEREO sound broadcast
When a stereo program is received, sound mode display will appear in red, and you can press the CH I / II button to select between stereo and mono sound. Each time the button is pressed, or � (force mono)appear cyclically on the screen. When receiving NICAM signals, NICAM display will appear as below.
Sound multiplex signal received
Red Green
NICAM signal received
NICAM Red Green
Select
or
(force mono) to hear the STEREO or MONO broadcast respectively. 8
Monaural sound broadcast
When a monaural program is received, sound mode display will appear in green. You can press the CH I / II button to select the sound mode between monaural and forced mono (sound is same). Each time the button is pressed, or � (force mono) appear cyclically on the screen.
NOTE
� If sound signal is not strong enough for quality reception, press the CH I / II button until � appears on the screen to receive a clear mono sound. � If sound has hiss noise or keep switching between stereo and mono mode due to signal condition, press the CH I / II button until � appears on the screen to receive a clear mono sound.
53
ENGLISH
OTHER FUNCTIONS
|
|
|
> |
|
