Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
Great to be able to set channels again, on an old but stoll fine working TV
Text excerpt from page 65 (click to view)
4. Fasten the wall-mount unit securely to the wall. G Clamp to two or more of the long slotted holes in the upper and lower parts of each wall-mounting metal in a well-balanced manner.
5. Dressing the cables G When passing the plasma TV power cord and signal cables behind the plasma TV, use wire clamps, etc., to prevent cable damage.
Mount on a firm, solid surface. Wall-mount metal (top)
Wall-mount metal (bottom) Use the washers provided as necessary.
Mounting the TV-mount metals on the plasma TV
1. Remove the stand. x Place a protective sheet cover on the top of a table and place the plasma TV on the cover with the back side upward. â Remove the 4 EMI ground screws. (for CL32-PD2100 only.) â Remove the 4 or 5 (CL37-PD2100) screws fastening the stand and remove the stand in the direction indicated by the arrow mark.
Remove the 4 screws Remove the 4 EMI ground screws.(CL32-PD2100)
2. Installing the TV-mount metals
IFasten the two TV-mount metals to the back of the
plasma TV with 4 M6 x 18 screws.
4 M6 x 18 screws TV-mount metal
The 3rd TV-mount metal hole
Remove the screws (CL37-PD2100)
Table Stand Protective sheet cover
The 4th TV-mount metal hole