|
Who's Online
There currently are 5909 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
;
The Service Manual for Sansui AU-9500 was very helpfull, in complete and in good printable condition.
Thanks.
;
Dear Sir,
Document is original service document of sharp. I had a problem with the door contacts. Fuses where blown. With the manual in a few minuts is was clear what the problem was.
Manual was of great help.
With kind regards,
Martie Verhoeven
The Netherlands.
;
The scan is clear and well readable with very few weaker spots, usually on black background with white letters, but with enough zoom those spots can be read.
Printout is clear, the manual is complete and has all pages scanned.
I would give 5 stars, except that it is not in color, and the schematic and PCB pages are scanned on multiple pages. The document is locked (except printing) so the pages can not be extracted to compose them together for printing on the large plotter
It is worth the price tag.
Wiring of the circuit power supply (2/2) Wiring of the circuit power supply board (1)Style the CNPOW, TSW, and FG3. (2)Attach the CNSH2 (3)Attach the power supply sheet. (4)Style the CNPWR.
TSW Fastener
Lock the CNPOW, TSW, and FG3 by passing them through the power supply case fastener.
Make sure to pass the CNSH2 through the hole indicated in the diagram below. [CAUTION] Make sure to attach the power supply sheet after attaching the CNSH2.
Power supply case
CNPOW
FB5
Pass the CNPWR through the hole in the power supply sheet, and pull the wire out. When pulling out the CNPWR and FB2, make sure that they do not pass over the C104 (electrolytic capacitor), as this will cover the anti-explosion valve on the top of the capacitor.
View from above
C104
CN102
FG3 Power supply sheet CN103 C104 FG1
FB1
CP-S240(CC9SM)/CP-X250(CC9XM)
Circuit power supply
CN101 FB2 CNSH2
E2
31
View from the side
C104
Fasten the CNSH2 and E2 with tape, ZTP1 and ZTP2, after passing them through the clamps of the power supply case. [CAUTION] As the upper case touches the gray areas of the diagram on the right, make sure no wires protrude into these areas.
CNPWR
ZTP2
Clamp Clamp
Power supply sheet
Power supply sheet
C104
C104
Correct (solid line) Correct Incorrect
Louver of the power supply case Incorrect (dotted line)
Outline of power supply case holes
Don�t wire the E2 on the louvers. The solid line in the diagram indicates an example of correct wiring. The dotted lines in the diagram indicate examples of incorrect wiring.
ZTP1
Fasten the E2 with tape ZTP1. Make sure to stick the tape along the outline of the power supply case holes as shown in the diagram.
Wiring diagram 2
|
|
|
> |
|