|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
 ;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
NOTE: If the air filter is used when wet,suction is impaired and the motor may be damaged. *EXHAUST AIR FILTER(CV-80D, Fig.10,11) HYGIENIC AIR FILTER(CV-80DC, Fig.10,11)
Your vacuum cleaner has a highly efficient electrostatic exhaust air filter(64)(65) to trap even the finest dust particles in the exhaust air. Once or twice a year,when the filter gets dirty,change the filter as follows. 1. Open the front cover(62)(63). 2. Remove the old filter from the cleaner. 3. Fit a new filter in the cleaner.
Front cover
Fig.10
Air filter
*HEPA CLEAN FILTER(CV-80DP, Fig.12)
Your vacuum cleaner has a highly efficient electrostatic exhaust air filter(64) to trap even the finest dust particles in the exhaust air. Once or twice a year,when the filter gets dirty,change the filter as follows. 1. Open the front cover(62). 2. Remove the old filter from the cleaner . 3. Fit a new filter in the cleaner.
Fig.11
HEPA clean filter
Fig.12
5. FINAL TEST
(1) After reassemblage,run the cleaner for at least 15 minutes and be certain that there in no abnormal vibration. (2) Measure the insulation resistance between the power supply plug and the metal surface by 500V DC insulation resistance tester and be certain that the insulation resistance is not less than 10M ohms.
-6-
|
|
|
> |
|
