|
|
|
Who's Online
There currently are 5460 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good Quality of the File.
You get the normal manual is incudet.
;
Very nice and real Service Manual, I didn't thought it actually exist in the real world at all.
 ;
VERY NICE FOR COURTESY AND PRECISION!.
tHE SITE IS VERY IMPORTANT FOR ALL DEVICES
vERY GOOD
;
+++ Is is fine, that was what i looking for. Thanks! +++
;
A very good complete archive, i am very satisfied for document.
Disassembly and Reassembly > Checking Mode after Reassembling Deck Mechanism
4-5 Checking Mode after Reassembling Deck Mechanism
After disassembling the deck mechanism, check the positions of the following gears when reassembling it: If the positions of gears drift, the deck mechanism will not operate normally. Turn the cam gear with the L/D motor assembly removed, and make sure that loading and unloading are performed normally. 1) Make sure that hole (A�) in chassis on the surface of deck mechanism is aligned with hole (A) in cam gear: If they are not aligned, remove the L/D motor assembly, and then turn the cam gear until the holes are aligned. 2) Make sure that the small hole in cam gear on the back of deck mechanism is aligned with hole (B) in drive gear: If they are not aligned, remove the drive gear, align their positions, and then reassemble the gears.
L/D Motor Ass'y
Cam Gear
(A') (A) Hole in Chassis Hole in Cam Gear
Top View of Deck Mechanism
Fig. 4-5-1 Cam Gear Position Alignment
Cam Gear
(B) Drive Gear
Bottom View of Deck Mechanism
The holes in cam gear and drive gear must be aligned.
Fig. 4-5-2 Drive Gear Position Alignment
4 - 18
|
|
|
> |
|
