|
Who's Online
There currently are 5904 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
;
Excellent, fast delivery, excellent product. Good luck!
;
This manual is for the usa model only. But it is clear
, accurate and comprehensive, including board layouts and schematics.
I found it extremely useful for my mitsubishi dp-86da, but the same diagram would also work for the realistic lab5000 and hi fi 80. Thanks.
;
Great to have extra resources for Service Manuals, Now days you can really not trouble shoot efficiently without one , Wayne at IRIONS TV & ELECTRONICS REPAIR Clearwater , Fl. 33755 727-446-7955
;
For five bucks you can barely buy a hamburger. Or for the same five bucks you can buy a service manual. Much more useful. (and better for your health, depending on where you buy your hamburgers).
Yes, there are free manual sites out there, but if they don't have what you want, you have to pay.
And five bucks isn't much. Not for full specs, schematics and adjustment and parts replacement procedures.
My only criticism is that grayscale illustrations aren't well rendered, but I've seen worse.
Schematics and text are clear.
I'll be happy to purchase from here again.
Mike
[email protected]
2-3
2. Einbau von FLATPACK - Bauteile a. Verwenden Sie eine Ablötlitze, um Lötrückstände an den Lötaugen des Prints zu entfernen. Damit wird die Montage der neuen FLATPACK-Schaltung erleichtert. b. Die Markierung ��� auf der Flatpack-Schaltung kennzeichnet Pin1. Diese Markierung mu� mit dem Kontakt 1 auf dem Print übereinstimmen. Löten Sie die vier Ecken der Schaltung an (siehe Abb. 2-9).
Spannungsmessungen
Farbtestbalken bei AUFNAHME und WIEDERGABE bei Normalgeschwindigkeit. Anmerkung: Die Spannungen bei AUFNAHME und WIEDERGABE sind in den Diagrammen gemä� nachstehender Abbildung angegeben.
BEISPIEL
AUFNAHME u. WIEDERGABE (gleiche Spannung für beide Modi) WIEDERGABE-Mode Pin 1 der FLATPACK-Schaltung ist mit der Markierung ��� gekennzeichnet. Abb. 2-9 AUFNAHMEMode Abb. 2-11
Vorlöten Lötkolben
Oszillogramme
1
Me�punkt Amplitude Zeitbasis Betriebsmode
2 3 Print FLATPACKSchaltung Abb. 2-10 c. Löten Sie alle Pins der Flatpack-Schaltung an, wobei darauf zu achten ist, da� kein Kurzschlu� zwischen den Pins entsteht. 4
4
Anmerkung
Alle integrierten Schaltungen sowie zahlreiche andere Halbleiter sind empfindlich gegen elektrostatische Entladungen und sind daher gemä� den Vorschriften im Kapitel �Sicherheitshinweise� zu behandeln.
2
1
Abb. 2-12
3
Spannung der Z-Dioden
Die Z-Spannung der Z-Dioden wird als solche in den Schaltungen ausgewiesen: Beispiel: BZX79C20............Z-Spannung: 20 Volt
D
|
|
|
> |
|